With its sturdy construction and IP65 protection, the bus module can be mounted directly on the outside of the machine or system without requiring additional protection. Sensors and/or actuators can be connected via highly reliable M12 plugs. Available for PROFIBUS-DP and INTERBUS-S

TECHNICAL DATA		PROFIBUS-DP	INTERBUS-S
Versions		8 outputs	8 outputs
		16 inputs	16 inputs
		8 imputs + 4 outputs	8 inputs + 4 outputs
Supply voltage		24 Vdc (18V......30V), approx. 100 mA
Degree of protection		IP65
Temperature		0÷55°C (32÷131°F)
Field Bus data	Transmission protocol	Profibus-DP DIN E 19245	Interbus-S DIN E 19258
	Transmission method	Synchronous or Freeze-Mode
	Transfer speed	12MBit/s	500KBit/s
	Addresses	Rotary switches BCD, 3...99
Input technical data	Type	pnp proximity sensors or IEE 1131-2 compatible mechanical limit switches
	Voltage	24VDC (from 18V to 30V) , max. 100mA simultaneously
	Indicator light	Each input has a LED
Output technical data	Voltage	24VDC (from 18V to 30V) max. voltage 2A for each actuator
	Max. exchange current	2A, system protected by short-circuit fuse
	Max. connectable load	10W
	Max. signal exchange frequency	100 Hz Ohm, 1 Hz induction
	Indicator light	Each output has a LED
Autotest	Field bus	RUN-LED	BA-,RD-,RC-LEDs
	Insuff. voltage signal	LED + alarm signal to master
	INPUT short-circuit sensor	LED + alarm signal to master
	OUTPUT short-circuit sensor	LED + alarm to master
NB: The slaves come complete with cable glands

COMPONENTS
In-out connectors When the Slave is 8 OUT, each connector corresponds to an OUT. When the Slave is 16 IN, each connector corresponds to 2 IN. In-out connectors Autotest LED IN power connector OUT power connector Connector for IN bus Connector for OUT bus