HomeProductsInnovations for Automation E-Mail
Fittings Miniature Flow Control
     This LINE-MOUNTED flow micro-regulator with built-in push-in fittings has the job to regulate the air supply and thus, the speed, in pneumatic actuators.  Two versions are available:
  1. Type U (unidirectional) regulates the flow in one of the two directions of air flow.
    Configurations:
    • Push-in fitting at the inlet and outlets
    • Push-in fitting at the inlet and threaded port at the outlet (Cylinder)
    • Threaded port at the inlet and push-in fitting at the outlet (Valve)
  2. Type B (bi-directional) regulates the flow only in both directions of air flow.
    Configurations:
    • Push-in fitting at the inlet and outlet
    • Threaded port and push-in fitting

     There are three fixing options

 Serie RFL R
   
TECHNICAL DATA Ø 6 Ø 8
Max operating pressure MPa 1
bar 10
psi 145
Temperature range °C
°F		 from –20°C to +80°C
-4°F÷+176°F
Max flow rate on regulation* Nl/min 450 850
Flow rate on relief* Nl/min 550 950
Adjustment manual or using a screwdriver
Internal system Tapered needle
Recommended pipe Rilsan PA 11 - Nylon 6 - Polyamide 12 - Polypropylene
Fluid lubricated or unlubricated filtered air
    *(at 6.3 bar)
   
COMPONENTS
  1. Technopolymer body
  2. Nickel-plated brass seal support
  3. NBR gasket
  4. Brass adjusting needle
  5. Nickel-plated brass needle ring nut
  6. Nickel-plated brass wall fixing ring nut
  7. NBR seal
  8. Technopolymer spring ring
  9. Stainless steel clip-on spring
  10. Technopolymer stop bushing
  11. Technopolymer release bushing