|
||||
 |
Mach 16 Valves |  |
||
|
||||
|
Mach 16 Valves | |
||
| Mach 16 valves - available in
1/8" only versions 5/2 and 5/3 and with pneumatic and solenoid
actuation. The MACH 16 valve is a typical small size valve, only 16mm
wide, with excellent performance, 750 NI/mn flow rate at 6 bar, AP 1 Bar. The valve can be used in line, or a panel, or on a base (multiple manifold). This MACH design, is the result the miniaturization concept with the same durability, sturdiness and reliability. |
 |
| TECHNICAL DATA | |
| Valve port thread |
1/8" |
| Type of Pilot |
Pneumatic actuation M5 |
|
Solenoid actuation with integrated coil |
|
| Max. outer diameter of fitting |
15mm |
| Flow rate at 6 bar AP 0.5 bar | 540 NI/min |
| Flow rate at 6 bar AP 1 bar | 750 NI/min |
Operating Temperature |
-10ºC + 60ºC |
Minimum actuation pressure |
Monostable with pneumatic spring |
pilot - pneumatic controls |
1.6 bar for monostable valves with mechanical spring |
| 0.9 bar for bistable valves - 1.9 for 5/3 valves | |
| Max. operating pressure | 10 bar |
| Fluid | Filtered lubricated or unlubricated compressed air; |
| lubrication if used must be continuous | |
| Recommended Lubricant | ISO and UNI FD 22 |
| Number of ways in base | 1-3-5 and Pilot Exhaust |
| Screws for wall mounting single valve | 2 M3 screws |
| Screws for base-mounting valve | 2 M2.5X30 screws |
| Installation | In any position (vertical mounting is not recommended for bistable valves |
| subjected to vibration) | |
| Response times (TRA at 6 bar) | 12 ms (5/2 monost.) to 18 ms (5/2 bistable) |
| during actuation (m/sec.) | 23 ms (5/3) valve) |
| Response times (TRR at 6 bar) | 26 ms (5/2 monst.) to 22 ms (5/2 bistable) |
| repositioning (m/sec.) | 21 ms (5/3 valve) |
| Conductance C NI/minbar | 149.8 (5/2 valves) to 163.4 (5/3 valves) |
| Critical ratio b bar/bar | 0.525 (5/2 valves) to 0.491 (5/3 valves) |
| COMPONENTS | |
|
 |
|
Flow Chart |
|
|
|
